Sometimes parts labeled as surface mount aren't quite ready for prime time. I've written about this subject before (read here), and I'm going to write about it again - whether you like it or not. This time, however, I'm not talking about components that aren't up to thermal par. Today, it's about components that can take the heat, but aren't set up to be machine assembled.

Surface mount machines need a flat surface to pick on. They use small vacuum nozzles that need to seat on that flat spot. Chips, of course, are flat on top, as are most other components. Connectors, however, are often not flat on top. That doesn't leave any place for the "pick and place" machine to pick.

Single row header with pick and place padGenerally, manufacturers will place a small tab of KaptonĀ® tape or a small snap-in plastic pad on top of the connector, giving the machine a surface to work with. You can see that in the photo on the left. Once the board has been fully assembled, the tape or plastic pad is simply removed.

Every now and then, we'll see connectors come in without that flat pick and place surface (like on the right). That means the machine can't place it, so it will have to be placed by hand. 1.25mm-Wafer-SMT-Connector

When buying your surface mount connectors, if you have a choice between a part with the tape and one without, you're better off picking the one with the tape. No offence intended to all of you humans, but machine assembly is generally preferred over human assembly.

Duane Benson
Only three more days until Mitten Tree Day!