Advertisement
Industrial
Subscribe to Industrial
View Sample

FREE Email Newsletter

Laser Beam Analysis Software Adds Support for High Speed GigE Cameras

February 28, 2011 7:27 am | Product Releases | Comments

Ophir Photonics announced that its BeamGage laser beam analysis software, now supports GigE cameras for high-speed applications. GigE (Gigabit Ethernet) cameras provide high speed, up to 1 Gigabit/s transmission rates, in a

Test Tools Operate in High-hazard Environments

February 28, 2011 7:18 am | Product Releases | Comments

Fluke has introduced a new family of Fluke clamp meters and a new four-channel hand-held oscilloscope — engineered to give electricians and maintenance technicians new ways to work safely and reduce their exposure to electrical shock. Fluke 381, 376, 375 and 374 current clamps and iFlex current probes are rated for

TI demonstrates industrial sensor solutions

February 25, 2011 10:42 am | by texasinstrumentsVlog | Videos | Comments

The Industrial sensor pod at SPS Drives 2010 shows how we address the topics of Energy Efficiency, Integrated Industrial Communication, Safety and Security and Industrial RFID. The basis for many industrial sensor applications is a MCU that can run off a single battery for 10, 15 or even...

Advertisement

MCUs Add Space-Saving Socket Option

February 22, 2011 9:19 am | Product Releases | Comments

Energy Micro is making its EFM32 Gecko and Tiny Gecko product lines available in the space-saving QFP48 package. The smaller 48-pin ARM Cortex-M3 based microcontroller options will enable manufacturers to

Profibus RS-485 Transceiver Integrates Driver for High Eficiency and Low EMI

February 16, 2011 10:14 am | Product Releases | Comments

Texas Instruments introduced an isolated half-duplex differential line transceiver with integrated transformer driver. The ISO1176T provides the primary voltage for an isolation transformer and

Power Connectors Suit High Amperage, Multi-phase Motor Apps

February 11, 2011 6:51 am | Product Releases | Comments

Amphenol Industrial offers a connector series designed to eliminate bulky and space-consuming cable glands on motors, AC/DC inverters and converters and other high amperage equipment. The IP67-rated ePower 400A connectors are

Fine Pitch Bump Adapters Allow for SMT Adaptation of TSSOP, QFP

February 11, 2011 6:45 am | Product Releases | Comments

Aries Electronics offers a line of adapters which convert TSSOP, QFP and other fine pitch devices to any other fine-pitch bumped package or routing configuration down to 0.4mm pitch. These Fine Pitch Bump Adapters are

Stamped Spring Pin BGA Socket Addresses Burn-in Characterization

February 11, 2011 6:41 am | Ironwood Electronics, Inc. | Product Releases | Comments

Ironwood Electronics recently introduced a BGA socket addressing burn-in characterization requirements for BGA devices - CBT-BGA-6011. The contactor is a stamped spring pin with 19-gram actuation force per ball and cycle life of 500,000 insertions.

Advertisement

Universal Thermocouple Connector Accepts Signals from Nine Thermocouple Types

February 11, 2011 6:14 am | Product Releases | Comments

Omega’s UTC-USB universal thermocouple connector accepts signals from nine thermocouple types (J, K, T, E, R, S, B, C and N). Through the USB port, the connector displays

Resistors Tout Desirable Surge Handling and Failsafe Operation

February 10, 2011 11:53 am | Product Releases | Comments

The WWF Series from Stackpole is designed to withstand thousands of surges at 6 kV without failing, but will fuse without fire, explosion, or fragmentation under continuous 240 VAC overload. The company's fusing technology combines

IR Detector Families Offer Desirable Sensitivity

February 10, 2011 5:51 am | Product Releases | Comments

Cal Sensors launched families of lead salt infrared detectors as well as a new digital drive board. The new single channel detector (SCD) and multichannel detector (MCD) families tout sensitivity and quality for a variety of infrared sensing applications. The new digital drive board optimizes

TouchSystems Monitor Includes Multi-Touch Support for Windows 7

February 10, 2011 5:47 am | Product Releases | Comments

The Elo TouchSystems 2242L touchmonitor includes IntelliTouch Plus surface acoustic wave product technology. It provides OEMs and software developers a ruggedized, 22-inch open-frame touchmonitor built to reliably run multi-touch gaming, wayfinding, concierge services and other touch-powered self-service programs.

LED PAR Lamps Add New Beam Angle and Color Temperatures

February 10, 2011 5:42 am | Product Releases | Comments

LEDnovation announced production availability of additional color temperatures and a new beam angle for its EnhanceLite line of LED PAR lamps. With the addition of 2700K and 4000K color temperatures and 55° “wide flood” beam angle, this line is

Advertisement

Vision Sensor with Ethernet Easily Integrates Into Factory Networks

February 9, 2011 11:14 am | Product Releases | Comments

Cognex Corporation announced the addition of the Checker 4G Series to its line of vision sensors. This vision sensor offers the same setup offered by the company’s Checker devices, and it adds Ethernet networking for remote setup and monitoring, PLC communication through

Digital LED Driver IC Delivers Flicker-Free Dimming for Commercial, Industrial Apps

February 9, 2011 9:57 am | Product Releases | Comments

iWatt, Inc. expanded its family of digital LED driver ICs with a two-stage, power-factor-corrected (PFC), primary-side-regulated, leading- and trailing-edge-dimmable, AC/DC Digital PWM Controller targeting 120 V/230 VAC offline

High Intensity LEDs Retain a High Level of Light Quality

February 9, 2011 9:35 am | Product Releases | Comments

The new 15-W and 25-W Mega Zeni models from Sharp are compact, lightweight, and extremely bright, whilse still providing a very high level of light quality. The new models produce a light output of up to 2550 lumen (depending on the module), a luminous flux of up to

LED Driver Handles Higher Voltage Off-line Illumination

February 9, 2011 9:07 am | Product Releases | Comments

Provided in standard SO-8 and high power dissipation exposed pad SO-8 packages, the AL9910 high brightness LED driver from Diodes Incorporated will support universal AC input voltages from 85 V to as high as 265 V. For interior and exterior off-line lighting products, the exposed pad SO-8 variant in particular helps

LED Driver ICs Deliver Flicker-Free Dimming, Hot-Plug Support

February 9, 2011 7:22 am | Product Releases | Comments

iWatt, Inc., announced two primary-side-regulated, leading- and trailing-edge-dimmable, AC/DC digital PWM controllers targeting 100 V/230 VAC offline LED lighting applications. Designed for isolated or non-isolated LED drivers used in incandescent replacement lamps including

Sensor Film Lets Users Check, Correct Surface Temperature Variations in Heat Sinks

February 8, 2011 11:09 am | Product Releases | Comments

Thermex thin sensor film can be used in virtually any application to test and monitor heated contacting surfaces from 200° to 300°F (93° to 149°C). It can be used alone or in conjunction with Fuji Prescale pressure indicating film

Railway DC-DC Converter Series Accepts Wide Input Voltage Range

February 8, 2011 6:23 am | Product Releases | Comments

Martek Power introduced a DC/DC converter designed to satisfy the majority of rolling stock DC power applications with a single unit. As a result, users are able to specify the same power supply

500-W Power Supplies Suit Medical and Industrial Apps

February 8, 2011 5:59 am | TDK-Lambda Americas, Inc. | Product Releases | Comments

TDK-Lambda Americas has added to its line of AC-DC medical, ITE (information technology equipment), and industrial power supplies. The single-output CSS500 Series of 360 W to 500 W supplies accepts a

Miniature DIN Rail-Mounted Circuit Breakers Are Rated to 125 A

February 8, 2011 5:48 am | Product Releases | Comments

Automation Systems Interconnect introduced a line of high current DIN rail mounted circuit breakers. The NDM1-125 Series is rated up to 125 A, is UL1077 Recognized for use as supplemental protectors, is available in 1-, 2- and 3-pole versions and can

AC-DC Open Frame Power Supply Series Adds 6-W Model

February 7, 2011 7:38 am | Product Releases | Comments

CUI, Inc. added a 6 W model to its open frame AC-DC power supply line. With the latest offering, the VOF Series covers a range of power from 6 W through 80 W. The series is suited for consumer, industrial, and ITE applications. All units are

Hall effect, 1000-A Current Sensor Supports Renewable Energy Apps

February 4, 2011 10:14 am | Product Releases | Comments

Premo has introduced a close loop 1000-A Hall effect sensor, the HCT-1000LF. Features and characteristics include accuracy to ± 0.1 percent, linearity of ± 0.1 percent, 1000-A nominal current; 2000-A measuring current, a transformation ratio of

Infrared LEDs Suit Proximity Sensing

February 4, 2011 9:36 am | Product Releases | Comments

A new series of high-performance infrared LEDs suited for proximity sensor applications is now available from ROHM Semiconductor . The SIM-030/031ST and SIM-040/041ST surface-mount IR LEDs feature a desirable IR wavelength technology providing

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading