Product Releases
Subscribe to ECN Magazine Product Releases

Micro Coaxial Connectors Are Smallest in Class

February 20, 2009 9:06 am | Comments

Targeting portable device applications, the FI-J Series micro coaxial connectors from Japan Aviation Electronics (JAE) are claimed as the smallest devices of their type, compared to other 0.4-mm pitch connectors. The connectors mounted dimensions are 2.5 mm deep x 1.58 mm high, with width dependent on pin count

SMPS Capacitors Handle High Currents, Frequencies

February 20, 2009 8:58 am | Comments

With capacitance values of up to 33 µF , the CSM Series of stacked Switch Mode Power Supply Capacitors (SMPS) from Tecate can withstand up to 500 VDC. The Capacitors are offered in EIA 1825 and 2225 size codes, and in both NPO and X7R dielectrics. Features include an input or output operating voltage

PLC Offers 400 Memory Lines

February 20, 2009 6:47 am | Comments

Including 254 symbolic variables and 6 programmable PID loops, Galil Motion Control’s RIO-471x2 Pocket PLC provides 400 lines of program memory. The device contains 8 analog inputs and outputs, 16 optically isolated inputs and outputs, a 32-bit processor, and non-volatile memory. The controller includes arithmetic and logical processing, process control loops, data logging, counters and timers. The unit communicates via


1206 Chip Fuses Rated to 20 A

February 20, 2009 6:10 am | Comments

Exhibiting a 100-A interrupt rating at rated voltage, Tyco Electronics’ new line of 1206 form factor chip fuses demonstrate rated current values of up to 20 A with voltage ratings up to 24 VDC. The halogen-free units help provide overcurrent protection on power supplies, servers, communications equipment, voltage regulator modules, and

SATA Compliance Test Software Enables 6-Gb/s Measurements

February 20, 2009 5:50 am | Keysight Technologies | Comments

Performing in Infiniium oscilloscopes, Agilent Technologies’ N5411B SATA compliance test software provides early 6-Gb/s physical layer transmitter measurements for users designing to the requirements of the SATA Revision 3.0 specification. The product test general specifications, transmitted signal requirements, and

Light-Load Regulators Address POL Applications

February 20, 2009 5:29 am | Comments

Using the company’s Simple Light Load Mode (SLLM) technology along with current-mode PWM control, the BD91x Series of point-of-load (POL) step-down switching regulators from ROHM Semiconductor are presented as having an efficiency improvement of up to 200% over devices using standard PWM controllers. The SLLM technique enables BD91x series regulators to seamlessly transfer to / from conventional PWM control depending on load conditions.

LED Emitters Deliver 87 lm

February 20, 2009 5:12 am | Comments

Coming in a 5-mm × 4-mm × 1.85-mm SOP package with a 165° viewing angle, Avago Technologies’ ASMT-Jx1x 1-W LED emitters yield a flux output of up to 87 lm at 350 mA. The moisture sensitivity level-one (MSL 1)-capable devices present a maximum allowable junction temperature of 150°C, ESD resistance of 16 kV, and color options including red, amber, green, blue, cool white, neutral white, and

CMOS Image Sensors Function Down to 15 cm

February 20, 2009 4:49 am | Stmicroelectronics | Comments

Combining on-chip Extended-Depth-of-Field (EDoF) with ST’s 1.75 µm pixel process, STMicroelectronics’ VD6853 and VD6803 3.15-megapixel CMOS image sensors enable image quality at focus distances down to 15 cm in phone cameras. The components embed 4-channel anti-vignette, and come in a TSV


Software Serves Mobile Applications

February 20, 2009 4:41 am | Comments

Optimized for Micron’s ONFI-standard single-level cell (SLC) NAND technology, Micron Technology’s NANDcode software supports mobile OSs including Windows Mobile 6, Linux, and Symbian. The product contains a flash translation layer (FTL) that employs

COTS Military Computer Uses MIL-STD-D38999 Connectors

February 19, 2009 11:08 am | Comments

Targeting military defense electronics, Adlink Technology’s MilSystem 800 Extreme Rugged COTS military computer utilizes MIL-STD-D38999 connectors instead of PC-style connectors. The device consists of the Ampro by ADLINK LittleBoard 800 SBC in a 8” × 10” × 3” MIL-STD-810-tested RuffSystem enclosure, and the system supports

Starter Kit Enables FPGA-based Prototyping Designs

February 19, 2009 9:35 am | Comments

Intended for use with Libero development tools, Actel’s IGLOO nano starter kit can be used for prototyping designs targeted to IGLOO or ProASIC3 nano FPGAs. The product includes a development board with an IGLOO

Modules Automate Key Measurement and Analysis Tasks

February 19, 2009 8:35 am | Tektronix | Comments

The DPOxAUDIO and DPOxPWR triggering and analysis modules from Tektronix are designed to automate key measurement and analysis tasks on digital audio buses and switch-mode power supplies. Features include the Wave Inspector search/navigation toolset and the TekVPI probe interface

Load Regulator Supports Appliances and Handheld Products

February 19, 2009 8:31 am | Comments

Delivering up to 1.5-A output current, the MIC23150 HyperLight Load Regulator from Micrel supports portable products and green home/office appliances. Features include: 23 Micro Amps of quiescent current, 93 percent peak efficiency, 87 percent efficiency under a 1 mA load, operating input supply range from 2.7 V to 5.5 V


POL Voltage Regulators Boast Benchmark Efficiency

February 19, 2009 7:56 am | International Rectifier | Comments

Targeting energy-efficient server, storage and netcom applications, International Rectifier’s Gen2 SupIRBuck POL voltage regulators deliver 4-A, 8-A, and 12-A output current with benchmark efficiency over the entire load range, according to the company. The 5-mm × 6-mm devices exhibit an input voltage range from 1.5 V to

Digital Pressure Gauge Uses Five-Digit Display

February 19, 2009 7:04 am | Comments

Leveraging MEMS-based sensing technology, Automation Products Group’s PG5 digital pressure gauge utilizes a 5-digit display with 0.40” characters. The device delivers 0.01-digit resolution through 100 psi, has ranges from vacuum to 500 psi and from 0 psi to 10,000 psi at ±0.25% accuracy of full scale. The unit incorporates a 9-V battery for self-powering; an all-stainless steel sensor, and a microprocessor-based circuit with


You may login with either your assigned username or your e-mail address.
The password field is case sensitive.