Advertisement
Product Releases
Subscribe to ECN Magazine Product Releases

Power Modules Demonstrate 60-W Constant Output

February 6, 2009 7:40 am | Comments

Exhibiting short-circuit protection, MTM Power's PMAS/PCMAS60 Series primary-switched AC/DC power modules deliver constant output Wattage of 60 W. The SMT units offer input ranges from 90 VAC to 264 VAC and 100 VDC to 353 VDC; and single output voltages of 3.3 VDC, 5 VDC, 12 VDC, 15 VDC, 24 VDC,

Analyzer Serves I²C Buses

February 6, 2009 6:42 am | Comments

Using a high-speed USB 2.0 interface, Corelis’ BusPro I2C analyzer offers an intuitive environment for I²C hardware debugging, software development, and in-system programming of serial EEPROMs. The instrument supports Standard-mode, Fast-mode, Fast-mode Plus (Fm+), and High-speed mode (Hs-mode) with I²C bit rates up to

Snap Switches Exhibit Long Electrical Life

February 6, 2009 6:17 am | Comments

Offering SPDT and SPST configurations with solder, quick connect, or PC terminals, C&K Components' LCA Series snap switches offer an electrical life of 50,000 cycles at 3 A at 125 VAC. The components demonstrate operating force of 140 g, maximum contact rating of 10 A at 125 VAC, and an operating temperature range from -10°C to 125°C. The RoHS-compliant units are suitable for motorized equipment, sump pumps,

TOPICS:
Advertisement

Converter Provides Output Levels from 30 KVA-480 KVA

February 6, 2009 6:15 am | Comments

Using MOSFET-based, switch-mode power conversion technology, the Elgar XWave AC power source/frequency convertor from AMETEK provides incremental output levels from 30 kVA to 480 kVA. A single cabinet can provide 120 kVA with multiple cabinets configured for outputs from 120 kVA to 480 kVA. The XWave provides up to 150 percent of rated output current for up to 7 seconds to handle loads with heavy in-rush currents

Doherty Amplifiers Offer Efficiency >40%

February 6, 2009 6:10 am | Comments

The BLD6G21-50 and BLD6G22-50 Doherty amplifiers from NXP Semiconductors offers efficiency of greater than 40 percent at an average power of 10 W. This enables 35% lower power dissipation under multi-carrier signal operation compared to class AB amplifiers. The BLD6G21-50 is designed for TD-SCDMA operation at frequencies from 2010 MHz to 2025 MHz, whereas the BLD6G22-50 operates at frequencies

X-Ray Generators Deliver Wide Output Range

February 6, 2009 5:48 am | Comments

Performing in X-ray systems used for XRD, XRF, and industrial and analytical applications, Spellman High Voltage Electronics’ DXM 1200W Series X-ray generators offer output voltages from 20 kV to 70 kV at a maximum power of 1,200 W. The 4.75” H × 12” W × 12” D instruments can be configured for either floating filament or

Surge Protectors Target ADSL and VDSL Applications

February 6, 2009 5:29 am | Comments

Based on TISP overvoltage protection technology, Bourns’ TISP4CO15L1N, TISP4CO20L1N and TISP4C025L1N thyristor surge protector devices (TSPDs) provide protection for ADSL, ADSL2, ADSL2+, VDSL, and VDSL2 ports in modems or telephone exchanges. The feed-through-packaged devices are designed to

FPGA Families Enable Improved Designs

February 6, 2009 4:29 am | Comments

Providing system designers with improved methodologies for creating FPGA-based system-on-chip solutions, the Virtex-6 and Spartan-6 FPGA families from Xilinx can deliver twice the capacity at half the power consumption compared to previous families. With a logic density of up to 760 K and more than 38 Mbit of BlockRAM and 2,000 DSP slices, these new Xilinx devices set new benchmarks in on-chip performance.

Advertisement

Photoelectric Sensors Offer Remote Teaching Options

February 6, 2009 4:16 am | Comments

Using push-button programming, Carlo Gavazzi’s PD30 Series photoelectric sensors allow remote teaching options in most models, so setup and programming of the sensor can be done away from the application. These same models also provide an option for locking the sensor settings. A muting version exhibits mutual interference protection, sensor alignment aid, and the ability to verify the sensor’s proper operation remotely via

SBC Based on Core2 Duo Processor

February 6, 2009 4:02 am | Comments

Offering BGA-based components, Dynatem’s CRD 6U single-slot CompactPCI/PICMG SBC integrates an Intel Pentium Core2 Duo L7400 or T7400 processor at 1.50 GHz or 2.16 GHz. The conduction-cooled module comes with wedge locks and a full-board heat sink for shock/vibration environments and temperature extremes. The platform

Power Splitters Intended for Broadcast Applications

February 5, 2009 10:36 am | Comments

With wraparound or single- sided terminals, 1-W two-way resistive power splitters from International Manufacturing Services (IMS) are intended for broadcast applications. These resistive power splitters have 6-dB evenly split attenuation and operate from DC to 20 GHz. The devices have an attenuation accuracy of ±0.5 dB and a VSWR of 1.3:1

Antenna Allows Functionality of Four Frequency Bands

February 5, 2009 10:30 am | Comments

A modular antenna assembly from Laird offers SDARS, GPS, AMPS, and PCS antenna coverage in one package. With a design of 16 mm, the base module is designed to fit multiple vehicle platforms with various roof curvatures. The base antenna is installed on the car in the factory, and houses both

Low-Profile Copper Cable Fits Tight Situations

February 5, 2009 9:07 am | Comments

Addressing the needs of dense, higher-port-count switch installations using 10 GbE, FCoE, or 8 Gigabit Fiber Channel, a low-profile SFP+ direct-attach copper cable assembly from W.L. Gore and Associates is half the cross-sectional area of OM3 fiber optic cable and one-third the size of 62.5/125 optical cable, with a significantly reduced bend radius.

Advertisement

Datalogger Software Addresses CP Remote Monitoring

February 5, 2009 8:22 am | Comments

Working in conjunction with FreeWave's line of FGRCP radios, FreeWave Technologies’ new PC-based DataLogger software targets Cathodic Protection (CP) remote monitoring. The product assists in remotely monitoring and reporting CP operational values for pipelines, tanks, structures, and other underground facilities that are

Gearmotors Exhibit High Continuous Torque Rating

February 5, 2009 7:54 am | Comments

Demonstrating corresponding fixed output speeds from 120 to 6 rpm, Bison Gear & Engineering’s VWDIR20 parallel shaft AC gearmotors demonstrate a continuous torque rating from 100 in./lb to 600 in./lb (11.3 N/m to 68.8 N/m). The devices utilize ¼-hp (186-W) 115-V, 60-Hz split-phase electric motors, and act as Von Weise

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading