Advertisement
Product Releases
Advertisement

Epoxy Touts Fast Set Up and Snap Cure

Fri, 05/07/2010 - 11:43am
one part epoxyMaster Bond EP17HT-3 one part epoxy sets up in 20 to 30 seconds and snap cures in two to three minutes at 250°F-300ºF. As a one part system, no mixing is required and the epoxy can be cured in sections up to 1/4" thick. Its working life is indefinite because it will not gel until heated above 200ºF. With a volume resistivity of greater than 1014 ohm-cm, EP17HT-3 has desirable electrical insulation and chemical resistance characteristics. It is resistant to a wide range of chemicals including water, oil and most organic solvents. Other typical features include a Shore D hardness that exceeds 85 and a tensile lap shear of 2100 psi. The adhesive has exceptional temperature resistance with a service operating temperature range of -60ºF to +400ºF. It is 100 percent reactive and contains no solvents or diluents.

Master Bond
201-343-8983, www.masterbond.com
Advertisement

Share this Story

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading