Advertisement

PXI Solid State Multiplexers

May 22, 2007 5:50 am | Product Releases | Comments

Pickering Interfaces is expanding its range of PXI switching modules with the introduction of a range of high density solid state multiplexers. Applications include switching DMMs for four terminal resistor measurements or as an input switch to data acquisition systems. The 40-680 is available in a choice of configurations ranging from a 160-channel single bank multiplexer, a 20-bank eight-channel multiplexer to a four-pole 40-channel multiplexer

LISTED UNDER: Test & Measurement
Advertisement

Next Generation Software for Cable Test System

May 22, 2007 5:48 am | Product Releases | Comments

A software upgrade has been released by CAMI Research for the CableEye cable and wire harness tester. The new software displays multiple, independent connector graphics with live video graphics to help easily visualize complex wiring. Users may drag connector images to the desired position on the left or

LISTED UNDER: Test & Measurement

Nineteen I/O Modules and Datalogging Software Added to Data Acquisition Platform

May 22, 2007 5:45 am | Product Releases | Comments

National Instruments nearly tripled the number of I/O modules available for NI CompactDAQ, adding several key measurements and capabilities to the USB-based modular data acquisition system. Additionally, every CompactDAQ chassis is shipped with the company’s LabVIEW SignalExpress data-logging software

LISTED UNDER: Test & Measurement

Signal Source Analyzer with 10X Throughput Over Its Predecessor

May 22, 2007 5:43 am | Agilent Technologies | Product Releases | Comments

Agilent Technologies introduced an enhanced model of what is said to be the world's fastest signal source analyzer, the Agilent E5052A. It features a tenfold improvement in measurement throughput and more precise analysis functions than its predecessor, as well as desirable performance in clock jitter measurement with a very low jitter noise floor

LISTED UNDER: Test & Measurement

System Monitor Eyes “Feel-good Data”

May 22, 2007 5:41 am | Product Releases | Comments

The new system monitor from Elma monitors and controls power supply voltages, temperatures and fan speed values. After the associated Eurocard (3U, 100 mm × 160 mm) has been integrated in the system, it can be accessed from anywhere in the world via the Internet and instructed to carry out commands. Owing to its platform independence, the unit can monitor VME, VME64x and CompactPCI. As it is designed as an open system, users can

LISTED UNDER: Test & Measurement

Flying-Probe Test and Programming Service

April 23, 2007 11:08 am | Product Releases | Comments

Texmac, Inc. is offering complete testing and programming services using Takaya APT-series flying-probe systems. These services are available to any electronics manufacturer who needs fixtureless tests performed on a contract basis

LISTED UNDER: Test & Measurement

Residual Bus Simulation Tool

April 23, 2007 10:59 am | Product Releases | Comments

The FlexRay rest bus simulation tool from IXXAT provides a simulation environment for one or more control devices so that they can be tested independently of other nodes. This includes the generation of message traffic that is necessary for the device to be tested and reaction to messages. The FlexRay CCM supports real-time rest bus simulation directly on the hardware via a Linux-based embedded programming environment

LISTED UNDER: Test & Measurement

Dual-Display Clamp Multimeters

April 23, 2007 10:55 am | Product Releases | Comments

Fieldpiece Instruments, Inc. has introduced its SC50 Series Dual-Display Clamp Multimeters. Models SC53 and SC52 allow HVAC/R field service technicians to measure Amps and Volts as well as non-contact voltage down to 24V for thermostats and measurements for continuity and ohms at the same time. These multimeters have a wire-grabbing jaw that makes it easy to separate and capture a wire from a tight bundle

LISTED UNDER: Test & Measurement

Firmware Development Kit

April 23, 2007 10:45 am | Product Releases | Comments

Acqiris is offering a complete firmware development kit (FDK) that simplifies application development on the embedded FPGA of the company’s SC240/210 streamer analyzers and AC240/210 signal analyzers. This design kit expands the capabilities of Acqiris streamer analyzers and signal analyzer cards which are targeted for real time signal acquisition and processing applications such as radar, electronic warfare, lidar, industrial process control, radio astronomy and physic beam control

LISTED UNDER: Test & Measurement

Underfloor Branch Circuit Monitoring System

April 23, 2007 10:35 am | Product Releases | Comments

Power Distribution, Inc. has announced its J Comm BCMS system that fits under a raised floor, and it will monitor current, voltage and other power related measures for up to 168 branch breakers. Its compact design facilitates installation, and it will help data center managers track and control the power usage in all

LISTED UNDER: Test & Measurement

Pulse Pattern Generator

April 23, 2007 10:27 am | Product Releases | Comments

The Simptronik SK-1000A handheld, high performance pulse/pattern generator produces digital clock and data signals up to 1 GHz. Features include wide frequency range of 10 MHz to 1 GHz, four-digit frequency resolution, 500 ps rise/fall time, wide amplitude range of 100 mV to 3V, low jitter, 15 ps rms, build-in PRBS data patterns and touch-screen control interface

LISTED UNDER: Test & Measurement

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading