Advertisement

Constant-Current LED Driver Allows Multiple Devices to Be Cascaded and Programmed Via One Serial Interface

January 21, 2008 5:13 am | Product Releases | Comments

Catalyst Semiconductor, Inc. has expanded its recently introduced family of large LED video display drivers with the CAT4008, an 8-channel, constant-current sink LED driver for billboard, marquee, instrument and other large, general-purpose LED displays. The device’s LED channels can operate with an output voltage on the LED pins as low as 0.4V (for 2mA to 100mA LED current), to enable more power-efficient designs.

LISTED UNDER: ICs

Protected Three-Phase 600V IC Featuring Extra Channel for PFC or Brake and Ground Fault Protection

January 18, 2008 6:53 am | International Rectifier | Product Releases | Comments

International Rectifier introduced the IRS26302D protected 600V three-phase gate driver IC with ground fault protection. The IC has a seventh gate drive channel for a power factor correction (PFC) switch or inverter brake, making it well-suited to medium power appliance motor control and many other general-purpose three-phase inverter applications. The controller integrates power MOSFET/IGBT gate drivers

LISTED UNDER: ICs

Ultra-Low-Jitter Clock Generators Provide High-Frequency Timing

January 15, 2008 9:24 am | Product Releases | Comments

Maxim Integrated Products introduced the MAX3624 and MAX3625 high-performance, quad/triple-output clock generators for network equipment. These devices use a low-noise VCO and PLL architecture to generate a high-frequency, ultra-low-jitter (0.36 psRMS) clock signal from a low-frequency crystal resonator or reference clock input. They help to reduce space requirements by only requiring an external

LISTED UNDER: ICs
Advertisement

Power Amplifier Input Stages Help Reduce Design Time

January 15, 2008 6:30 am | Product Releases | Comments

National Semiconductor Corp. extended its high-fidelity LME audio amplifier family with the introduction of a pair of 200V mono audio power amplifier input stages with low distortion. The LME49811 and LME49830 have scalable output power based on supply voltage and output device count. Designers can use the same base circuit design to create multiple power-level solutions up to

LISTED UNDER: ICs

Multi-Chip Module has Wide Input Voltage Range

January 15, 2008 5:58 am | Product Releases | Comments

Toshiba America Electronic Components, Inc. (TAEC) expanded its power multi-chip modules (MCM) with a single package, 35A, 30V synchronous step-down converter switching module for high-current, low-voltage applications such as servers, server point-of-load modules, desktop PCs, and game machines. The 56-pin TB7004FL is compatible with Intel’s DrMOS 1.0 specifications. The main components are MOSFET gate drivers and high-side and low-side MOSFETs

LISTED UNDER: ICs

High-Voltage, Single- and Dual-Supply SPDT Analog Switches with Low 3.6-Ohm On-Resistance

January 14, 2008 7:32 am | Product Releases | Comments

Vishay Intertechnology released two high-voltage, single- and dual-supply single-pole double-throw (SPDT) analog switches. The DG469 and DG470 devices are identical, except the DG470 provides an enable pin, which puts all of the switches in a high-impedance state, maintaining a “safe state” at power up and preventing accidental signal or power shorts. The new switches are

LISTED UNDER: ICs

Low cost I/O and DSP-optimized Devices for Automotive Electronics

January 10, 2008 8:36 am | Product Releases | Comments

Xilinx, Inc. introduced the XA Spartan-3A and Spartan-3A DSP FPGAs for use in automotive applications. XA Spartan-3A devices are I/O-optimized for low cost per I/O in the PLD industry with up to 1.4 million system gates and 502 I/Os. They are compliant with 26 popular single-ended and differential signaling standards, and support market-specific networking standards, such as CAN, MOST and FlexRay.

LISTED UNDER: ICs

Flexible Controller for Flyback Converters Reduces Parts Count

January 10, 2008 5:25 am | Stmicroelectronics | Product Releases | Comments

STMicroelectronics announced a flexible controller for high-performance flyback power converters, which can operate in fixed-frequency (FF) or quasi-resonant (QR) mode. The chip integrates protection capabilities commonly implemented with external components, and is useful for applications such as AC/DC adapters/chargers, monitors, DVD players, and set-top boxes. During light load, the chip enters a controlled burst state at low frequency with constant peak current

LISTED UNDER: ICs
Advertisement

CCFL Backlight Inverter Drive IC is Tightly Integrated

January 9, 2008 10:46 am | Fairchild Semiconductor | Product Releases | Comments

Fairchild Semiconductor's FAN7316 and FAN7317 are CCFL backlight inverter drive ICs for N-N half-bridge, push-pull, and P-N full-bridge LCD designs. A wide input voltage range, built-in open lamp protection, and open lamp regulation eliminate up to 30 external components in traditional four-lamp circuit inverter designs. The FAN7316 runs on 4.5V to 24V, and the FAN7317 uses 6V to 25.5V. Other features are

LISTED UNDER: ICs

Baseline PIC Microcontrollers Feature Non-Volatile Flash Data Memory

January 8, 2008 9:17 am | Microchip Technology Inc. | Product Releases | Comments

Microchip Technology Inc. announced the first two Baseline 8-bit Flash PIC microcontrollers with non-volatile Flash Data Memory (FDM) in 8- and 14-pin packages, the 8-pin PIC12F519 and 14-pin PIC16F526. These additions supplement the variety of integrated low pin count microcontrollers in the Baseline PIC microcontroller family. With the availability of 64 bytes of data memory—combined with an 8 MHz internal oscillator, a Device Reset Timer (DRT)

LISTED UNDER: ICs

RF System-on-Chip for Home Control Applications

January 8, 2008 6:38 am | Product Releases | Comments

Zensys announced ZW0401, a fourth-generation home control chip in the Z-Wave series. It is useful as an RF control platform for A/V and home automation devices. Specifications include USB 2.0, 30 general purpose I/Os, a third-generation Triac controller, integrated IR support for universal remotes, and support for sub-1 GHz and 2.4 GHz bands

LISTED UNDER: ICs

Low-Power 4 GB DDR3 Registered DIMM for Server Applications

January 8, 2008 6:13 am | Product Releases | Comments

SMART Modular Technologies Inc. introduced a low-power 4 GB DDR3 registered DIMM. The module has 8-bit DRAMs which can help reduce power consumption. It also has a quad-rank architecture an a single-register design for reduced memory bus loading. The data rate is 667 Mhz / 1333 MHz and the module is RoHS-compliant. Pricing is $400 in OEM quantities.

LISTED UNDER: ICs

Low Power Tuner IC Meets ATSC A/74 standards

January 7, 2008 10:10 am | Product Releases | Comments

MaxLinear announced the MxL5007T, a TV tuner IC developed for low-cost converter, set top box (STB) and other TV systems currently being designed for the FCC-mandated 2009 digital television cutover. Measuring 5 mm × 5 mm in a 32-pin QFN package, the IC features high levels of integration (including LNAs, baluns, tracking and loop filters, and integrated

LISTED UNDER: ICs

LDO Controller Offers Adjustable and Fixed 1.2V and 1.5V Output Voltages

January 4, 2008 9:22 am | Product Releases | Comments

Vishay Intertechnology released an LDO controller with adjustable and fixed output voltage options that uses external n-channel MOSFETs to provide extremely low drop-out voltages of under 50 mV at very high currents, up to 7A, with, according to the company, 80 percent efficiency. The SiP21301 device is designed for driving n-channel MOSFETs to power FPGAs, ASICs, and ASSPs in

LISTED UNDER: ICs

Integrated, Low-Power, Single-Conversion Silicon Tuner Meets ATSC Requirement

January 4, 2008 7:32 am | Product Releases | Comments

Maxim Integrated Products' MAX3540 integrated, single-conversion television tuner for ATSC and NTSC applications meets the sensitivity and adjacent-channel guidelines specified by ATSC Recommended Practice A/74, while consuming 760 mW. The tuner integrates a tracking filter and high-linearity front-end. Additionally, it

LISTED UNDER: ICs

Pages

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading