Advertisement
News
Advertisement

Speaking of Small Packages...

Fri, 10/14/2011 - 3:22pm

T'was a a dark and stormy night when the news came through. Joe Layout had been both dreading and preparing for years. But it had always been little more than rhumors from a far off land. It was a looming threat, always dancing in the distance, but never quite real.

Until now. 1.27mm, 1.0mm, 0.8mm, 0.5mm, 0.4mm... and now... drum roll please 0.3mm pitch. I just got Shrinking BGA pitch an email announcing an Amkor 8 x 8mm 368 ball BGA at 0.3mm pitch. Yikes.

There's still some controversy over the best way to make a 0.4mm pitch BGA land pattern. Some say says you need to use solder mask defined pads. Some say you still need to use the non-solder mask defined pads. Now we throw something 25% smaller into the mix.

The image isn't to exact actual scale - because I don't know how big your monitor is - but the parts are in relative scale from 1.27 pitch to 0.3 pitch.

Duane Benson

If you can't see it, you shouldn't eat it

SOURCE

Advertisement

Share this Story

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading