Advertisement
News
Advertisement

What about the LGA?

Thu, 01/06/2011 - 12:24pm
Screaming Circuits

I've written a bit about soldermask defined (SMD) vs. non soldermask defined (NSMD) pads for BGAs.

Quick summary: 0.5mm pitch or wider spacing, go with NSMD pads. 0.4mm pitch seem to need SMD pads to prevent bridging (unless the pads are staggered. Then NSMD is fine)

But what about the LGA (Land Grid Array)? It's different due to not having the solder balls. Does that make LGA a difference? According to Freescale and a few other manufacturers, in most cases, you should treat an LGA just like a BGA and use NSMD pads. However, if you need extra strength holding the pad on to the PCB, you may want to consider using SMD pads. As always, consult the data sheet for your specific part for the final word.

Duane Benson

Checkers anyone?

SOURCE

Advertisement

Share this Story

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading