Panasonic and imec present thin film packaged MEMS resonator with industry record Q factor and low bias voltage
The high Q factor was achieved by implementing a resonator that operates in a torsional vibration mode, and, by vacuum encapsulation of the resonator in a thin film package. This groundbreaking resonator paves the way towards miniaturization and low power consumption of timing devices used in a variety of applications such as consumer electronics and automotive electronics.
MEMS resonators offer enhanced miniaturization over conventional resonators such as quartz crystals and piezoelectric ceramics. However, state-of-the art MEMS resonators suffer from a low Q factor and a high bias voltage. Panasonic and imec developed a novel packaged MEMS resonator achieving the highest Q factor reported in the industry until now (220,000 at a resonant frequency f=20MHz (f•Q product of 4.3X1012Hz)) and low bias voltage by combining different advanced MEMS technologies.
The application of a torsional vibration mode enables low anchor losses and lower squeeze film damping compared to flexural mode resonators, resulting in a higher Q factor. Since the Q factor also depends on the ambient pressure and starts to decrease above a critical pressure due to viscous and squeeze film damping, imec and Panasonic vacuum encapsulated the resonator in a hermetically sealed environment. This thin-film encapsulation of the MEMS with a 4m thick SiGe film is realized with a monolithic fabrication process with the MEMS.Fig 2: SEM of a cross-sectional structure.
Fig 1 & Fig 2: Illustration of the torsional vibration mode and a SEM of a cross-sectional structure of the developed packaged MEMS resonator.
The narrow 130nm gap between the beam and drive and sense electrodes enables a low bias voltage (1.8Vdc) and thus eliminates a charge pump in the oscillator circuit. Moreover, using sacrificial layer etching through a microcrystalline silicon germanium layer minimizes the chances of deposition of the sealing material inside the cavity and thus enables to position the etching holes right above the beam surface, leading to a smaller chip size.
The packaged MEMS resonator was realized as part of imec’s CMORE service which offers heterogeneous integration services to the industry. Imec builds on its expertise in many research areas to tune and extend CMOS processes with new processing steps to make novel CMOS micro- and nanodevices, adding functions other than logic and memory to the chips. Possible applications of such MEMS devices are smart sensors, actuators, power scavengers, resonators, biochips, micro-implantable appliances, or solar cells. Imec’s CMORE services range from development-on-demand, over prototyping, to low-volume production.
News release can be downloaded at http://www2.imec.be/be_en/press/imec-news/memsresonatoriedm.html
Imec performs world-leading research in nanoelectronics. Imec leverages its scientific knowledge with the innovative power of its global partnerships in ICT, healthcare and energy. Imec delivers industry-relevant technology solutions. In a unique high-tech environment, its international top talent is committed to providing the building blocks for a better life in a sustainable society.
Imec is headquartered in Leuven, Belgium, and has offices in Belgium, the Netherlands, Taiwan, US, China and Japan. Its staff of more than 1,750 people includes over 550 industrial residents and guest researchers. In 2009, imec's revenue (P&L) was 275 million euro.
Further information on imec can be found at www.imec.be.
Imec is a registered trademark for the activities of IMEC International (a legal entity set up under Belgian law as a "stichting van openbaar nut”), imec Belgium (imec vzw supported by the Flemish Government), imec the Netherlands (Stichting imec Nederland, part of Holst Centre which is supported by the Dutch Government), imec Taiwan (imec Taiwan Co.) and imec China (IMEC Microelectronics (Shangai) Co. Ltd.).
Panasonic Corporation (based in Osaka, Japan) is a worldwide leader in the development and manufacture of electronic products for a wide range of consumer, business, and industrial needs.
imec: Katrien Marent, Director of External Communications, T: +32 16 28 18 80, Mobile: +32 474 30 28 66, firstname.lastname@example.org