Advertisement
Blogs
Advertisement

Pads on ground plane

Thu, 08/22/2013 - 8:47am
Screaming Circuits

Pour-no thermalGenerally, small pads for passive parts are connected  with a single PCB trace of equal size to each pad. That's the right way to do it.

However, sometimes, circumstances dictate a little different approach. The illustration on the upper right here shows something of a worst-case. This is for a snubber (resistor, capacitor pair) between two power planes.

A couple of things will likely happen. The power plane will act as a heat sink, preventing the solder paste on one side from melting, resulting in a poor connection. Or, the unequal melting could lead to surface tension pulling the part up, causing tombstoning.

Pour-with thermalMost designers are aware of that, but sometimes, thermals will be deliberately turned off to allow for better current capacity to and from the large power Mosfets (not shown). If that's the case, make sure that you can turn the thermals (see image on loer right) on or off by the part, rather than just by the plane.

Duane Benson
The rain falls mostly on the ground plane due to static attraction

Advertisement

Share this Story

X
You may login with either your assigned username or your e-mail address.
The password field is case sensitive.
Loading